Let's take a general look at the factors that influence the production capacity of a jaw crusher. Generally speaking, there are many factors that influence the production capacity of a jaw crusher.
1. Material hardness: Harder materials are more difficult to crush and cause greater wear and tear on the equipment. This results in slower crushing speed and lower capacity. Therefore, we need to be careful when selecting materials.
2. Material composition: The higher the content of fines in the material before the jaw crusher, the more it affects sand production, as these fines tend to stick and affect conveying. Therefore, materials with high fines content should be screened beforehand to remove as much fines as possible from the material to avoid affecting the normal operation of the jaw crusher.
3. Material fineness after crushing in the jaw crusher: The higher the fineness requirement, that is, the finer the material exiting the crusher, the lower the crushing capacity. This depends on specific requirements. If there are no special requirements, a medium-fine setting is generally sufficient.
4. Material viscosity: The higher the viscosity of the material, the more likely it is to stick. Materials with high viscosity can adhere to the inner walls of the jaw crusher's crushing chamber. Failure to clean these materials promptly can affect the crusher's efficiency and, in severe cases, even its proper function. Therefore, when selecting materials, it's crucial to ensure they are not too viscous.
5. Material Moisture: Materials with high moisture content are prone to adhesion within the jaw crusher, potentially causing blockages during conveying and discharging, and reducing sand production capacity.
